-
Enjoy XS650.com? Consider making a donation to help support the site.
XS650.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
gggGary
Latest activity Postings Media Albums About
-
-
gggGary replied to the thread Question about a bolt size.Here you go. You could probably chuck the head of a 15mm m6 bolt in a drill and reduce the end diameter on a bench grinder, done. Old... -
-
gggGary replied to the thread Hard shifting and slipping.Is the shift shaft moving freely? The lever should move up and down and snap back to the middle position. How does it shift with the...
-
gggGary replied to the thread gggGary's latest XS project "madness".Never trust an analog guy. He'll create a bunch of work.
-
-
gggGary replied to the thread Ebay listing ideas.Put an opening bid in for you.
-
gggGary replied to the thread Painting Tins. No really....mebby if bondo was translucent so you could stop JUST before the metal pokes through? I could never stop in time. Now shipping to Jim is...
-
gggGary replied to the thread Fork Brace Application and Potential Install Modification Question?.Not a fork engineer but I'd be carefully working the brace till the flanges are at 5 1/8" and parallel horizontally and vertically...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
