sherwin
XS650 Addict
I am ready to put the bottom end of my 79 XS650 engine together. It seems to me the top case may be warped because the crank does not sit flush in the case half. When one end of the shaft is seated on the locating pin, the other side is slightly up in the air, as though the middle of the case is higher than the sides, this is with the pins properly located.
Will things even out if I put the halves together and torque the bolts or do I need to pick up new case halves? Should I just try it and see what happens?
Also, it being winter and living in Minnesota I can only get my garage temperature up to about 50f. I did not notice any temperature range on the package but will the threebond still work well at lower temperatures? Or should I wait on this until the temps are warmer?
Thank you,
Sherwin
Will things even out if I put the halves together and torque the bolts or do I need to pick up new case halves? Should I just try it and see what happens?
Also, it being winter and living in Minnesota I can only get my garage temperature up to about 50f. I did not notice any temperature range on the package but will the threebond still work well at lower temperatures? Or should I wait on this until the temps are warmer?
Thank you,
Sherwin