My build thread

motorbreath

XS650 Addict
Messages
267
Reaction score
0
Points
16
Location
Dubuque Ia
After asking a ton of questions, and everybody always willing to answer and help, heres mine so far, the questions wont stop though... Just letting u all know.

33565_1561997326646_1136703026_31557458_456357_n.jpg

33668_1562874508575_1136703026_31558964_8173961_n.jpg

34689_1562007526901_1136703026_31557500_3800933_n.jpg

34714_1562001846759_1136703026_31557476_5627324_n.jpg

36071_1561101984263_1136703026_31555785_8308430_n.jpg

44207_1562876348621_1136703026_31558966_4343248_n.jpg

59595_1558444117818_1136703026_31549227_1837157_n.jpg

64375_1562006326871_1136703026_31557496_312775_n.jpg

65251_1558584641331_1136703026_31549831_5831984_n.jpg

65315_1561999166692_1136703026_31557465_2541942_n.jpg

66004_1562872628528_1136703026_31558962_4095125_n.jpg

66466_1562874708580_1136703026_31558965_389903_n.jpg
 
the final rake would be i have no idea i just cut and welded were i though it felt and looked good, i would say between 35 and 40, i know its not the proper thing to do, i shouldve measured but i didnt have anything to measure it with
 
no i didnt have the motor case bolted in when i welded it, but i set it in after i got it spot welded(cant think of the term right now) in. It fit pretty good, everything lined up.
 
Things can move from the final welding even when everything was right when it was tacked. Hope it all lines up for you now after the final welding. If not, it's not he end of the world, you'll just have to make it right or make a couple of new engine mounts. Good start on the project though.
 
Also, im pretty much a beginner at this fab stuff, but ya got to learn some how right, also any advice from anyone would be helpful

20110328162526.jpg
20110328162536.jpg
20110328162655.jpg
20110328162706.jpg
 
Back
Top