Hi guys, I took off the acorn nut & the centre pin was flush with the 10mm nut, you could turn the nut in & the pin would stay flush, turn the nut out & the pin would recede, can I take it that you just turn the nut in until it is flush, then stop?
The book doesn't say move the chain to the slack point, but I did anyway, by rotating the mill forward twice, then back 1/2 a turn.
Thanks, Roy.
The book doesn't say move the chain to the slack point, but I did anyway, by rotating the mill forward twice, then back 1/2 a turn.
Thanks, Roy.