Bob, the 93306-30302-00 bearing translates back to a 6303 bearing, which is an XS2 front wheel bearing...
Bob, the parts pics aren't clear on this, and I'm not sure of the XS2.
But on the XS1s, the round can flasher relay mounts to the bottom of the battery box by way of a round clamp. The flasher body needs to be grounded thru the round clamp, to the battery box. Which requires that the battery box be grounded...
Mailman
Went to order bearings and a seal from 123bearing. They have them, problem is they are in France. Shipping is costly.
Ebay
https://www.ebay.com/itm/TC-30-47-5...282509793676?_trksid=p2385738.m4383.l4275.c10
https://www.ebay.com/itm/16005-2RS-...188108?hash=item5d303bdd0c:g:DjIAAOxywbNQ9x5v
Bob, that's what is so good about this forum, always at least two or three people who have the answer to just about any question!
That picture of the parts looks just like what I have on my bench right now, well possibly with the exception of the "o"ring. Don' recall seeing that but it might still be stuck in the housing under some gunk!
If on second look you decide one or more of your bearings are questionable just say the word and these two will be in the mail Monday AM!
Ken in NY
Bob, the parts pics aren't clear on this, and I'm not sure of the XS2.
But on the XS1s, the round can flasher relay mounts to the bottom of the battery box by way of a round clamp. The flasher body needs to be grounded thru the round clamp, to the battery box. Which requires that the battery box be grounded...
No going to get from EBayDid you go ahead and pull the trigger on them? I also noticed that the shipping was ridiculously expensive , and figured something was up with that.
If you don't have one yet, get yourself one of these needle point attachments for your grease gun. It's excellent for injecting grease into bearings, and numerous other tight spots all over the bike .....
Here, I've just used it to inject the clutch cable elbow full of grease .....
As memory serves, are there some rubber dampers that fit in the driving dog recesses?Mailman
The outer side on mine had a 16005 bearing and a 30x45x5 seal. You can find the seal at 123bearings.
https://www.123bearing.com/seal-OAS...MIxYiDgLLo3wIVFh6tBh1k7gx-EAQYASABEgIe3_D_BwE
View attachment 132887
The inner side same bearing no seal at the bearing. It did have a o-ring around the outer bearing housing. I put my o-ring somewhere where I would not loose it and now can't find it.
View attachment 132888