Recent content by 650gts

Thanks. I'm not using a battery, but a capacitor. So I'm guessing that goes to the "B" post? Also, I already have the kill switch grounded. Do I need to ground both M posts?

Finishing up my wiring finally and could use a little help. I have a kickstart only bobber running Hugh's Handbuilt CDI system. Take a look at the pic I attached of the standard switch I'm using. Need to know what goes where. Thanks!

I'm wiring up my handle bar and wondering what to use for a signal switch on a 1" bar. I can't find much for toggle switches. Maybe I'm just not looking in the right place. What have you guys used on your rides?

Thank you!

I've been looking at so many wiring diagrams and I'm still confused. I want to wire up front and back brake switches. How do you do this so one or the other trigger the light? If they're both on the same circuit and you just use one switch isn't the circuit still open? I know there's a basic...

Engine and carbs are in. I’m going with K&N style air filters. I’m guessing the two larger hoses coming off the engine are air hoses to the original air boxes? Do I just remove them and cap off the ports?

I don’t think it’s solid.

I just realized how stupid my question was. It’s part of the hardtail. 🤦🏻 It’s voodoo vintage by the way.

I'm installing Hugh's CDI system on my bobber and want to mount the regulator on the bottom cross member of the frame. See picture. Is this hollow or solid? I want to drill and tap so I can bolt it in place. If it's solid I'll look for another place.

I'm installing Hugh's CDI system on my bobber and want to mount the regulator on the bottom cross member of the frame. See picture. Is this hollow or solid? I want to drill and tap so I can bolt it in place. If it's solid I'll look for another place. Thanks.

I'm hooking up the new CDI complete kit from HHB. It's a 78 Special with kickstart only. I'm not great with electrical stuff... Does this system replace/bypass the need for the points that I had on the original setup? There's no mention of what to do with that wiring in the instructions. Thanks.

Hi, I was wondering where I could get a basic harness. I'm building a bobber and at the point where I need to starting the wiring. I want something pretty basic. • Headlight Hi/Lo beam • Kick start only (Hughs Hand Built CDI system) • Front/rear directional • Brake light Handle bar switches...

Engine finally in. :cheers:

Not exactly sure of the spoke length but Mikes XS site sells the kit I used.

Hmm. I don't have any oil in it now. I might give that a try. Thanks.