Recent content by budgie955

NOW SOLD Yamaha YZF 125 Upside down forks, bars, yolks, brake caliper, spoked front wheel, disc and tyre, speedo drive, spoked rear wheel . sprocket and tyre, rear brake caliper and mount , swinging arm,footrests, and shock absorber (im told the shock is off a WRX125) , . All in good useable...

count me in

1979 YZ250 swinging arm for sale £75.00 ono + post PM me your email address for pics Collect Sheffield UK

Frame with V5 wanted any condition Thanks Dave Sheffield UK

The carbs have been cleaned, might have to get them done again.

Hi All I have started my project XS up for the 1st time and it runs, but mainly on the left cylinder. The right kicks in when you rev it up . It idles on the left pot and the right kicks in occasionally ,,Where to start please? Its had :- Carbs cleaned, new manifold rubbers, new gaskets...

Hi All Please can some one clarify how the brushes on the alternator are wired up? Firstly - is the inner brush wire green or brown? I have fitted a simplified wiring harness and a solid state reg/rectifier unit so do the brushes need isolating from earth? the bike is points...

That looks ok Paul, thanks for the info Cheers Dave

Hi I have a non standard rear master cylinder on my project 650 which i need to rebuild - can anyone identify it so i can buy the correct kit? Thanks Dave Sheffield UK

i am guessing the wheels and forks are from the same bike, wheel pics attached thanks

17 inch front - 18 inch rear The forks need new tubes, they are air assisted, any ideas what model?

Hi it is all standard internally, the pistons were rusted in the bores, but the bottom end is spot on. Dave

Hi all I have just acquired an XS flat tracker project with some nice 3 spoke wheels, matching shocks, box section swinging arm, air forks and twin piston brake calipers, but can anyone identify what bike these parts are off please? thanks Dave