Recent content by Cadergray

  1. C

    M-Unit Wiring (Starter)

    Awesome when I get home this evening I will check it out thank you!
  2. C

    M-Unit Wiring (Starter)

    Ok so thank you for the help we now have spark and to answer your questions the M-Unit has a lock that I can control, and the kill switch will be added later on in the build. Now when I had the spark plugs pulled for testing, the starter motor ran great but when I put the plugs back in the...
  3. C

    M-Unit Wiring (Starter)

    First time using a wiring diagram software, sorry it's pretty bad but it should get the point across. The black and white wire from the TCI is disconnected as well as the red and white wire from the TCI. Let me know if you have any questions!
  4. C

    M-Unit Wiring (Starter)

  5. C

    M-Unit Wiring (Starter)

    Yes I could draw that up for you!
  6. C

    M-Unit Wiring (Starter)

    Should I not run red through the m unit for power? And orange is connected to the orange on the TCI
  7. C

    M-Unit Wiring (Starter)

    Alrighty I have a new starter that runs beautifully, now the next issue is no sparky spark, I seem to have everything wired “correctly” with the power wire from my coils put in the Ignition output on my M-Unit. Any suggestions?
  8. C

    M-Unit Wiring (Starter)

    Ok I will do some research on who sells them, thank you
  9. C

    M-Unit Wiring (Starter)

    Ok thank you, this is why I was leaning toward getting a second hand starter from someone or at least the hardware from somebody.
  10. C

    M-Unit Wiring (Starter)

    Thank you, do you know where I can source new bolts for the whole starter? Mine were so siezest in there I had to extract them and I will have to do the same thing to the 4 large Philips head screws.
  11. C

    M-Unit Wiring (Starter)

    Ground was good this time but the solenoid would click and the starter would jolt but not crank the motor over
  12. C

    M-Unit Wiring (Starter)

    Alright J I have returned from drill, I pulled the starter this morning and it was very rusty and I had to extract the bolts this ruining them. The barrel of the starter and the copper pads are very worn and have surface rust. I think it would be in my best interest to get a new or used starter...
  13. C

    M-Unit Wiring (Starter)

    Thank you Jessie and Jet I appreciate the help, any keyless cap recommendations?
  14. C

    M-Unit Wiring (Starter)

    So is there a way to get the old cap off without the key? I’m going to replace the cap and I don’t need the original ignition key because I am putting a new one in. I don’t have a local locksmith because I live in the boonies.
  15. C

    M-Unit Wiring (Starter)

    Thank you very much
See more
Back
Top