Recent content by dirtystanchez

Looks good Kush! I think you bought your bike from my brother, Kevin. If so, you picked it up at my house in Aurora back in January-ish. Am I correct? ~Stan

My bike is almost complete! So I'll be down for a ride in the next few weeks. ~Kushlife = Did you buy your bike from my brother Kevin back in January? I think it was you, you came down to my house in Aurora, with your wife/gf. It was an 83 heritage.

Rebel petcock wouldn't clear the intake so I replaced it with low-pro style. Drag Pipes Wrapped. Tank will be re-painted with gloss black and white stripe.

Time for updated pics.... Basically didn't touch the bike all winter and then picked it back up a few months ago. Bike is running now. Took it for a 20 mile ride 2 weeks ago. Then I was able to score some white-walls, sprockets, and I decided to polish the forks. Not finished yet but close. New...

Thanks, I'll give it a shot.

Hi everyone, Is anyone running a single VM36/38 carb setup in Colorado or similar altitude? (5,000 ft) I'm trying to get a base jetting combo. The carb I have was not stock. I currently have these jets to play with. Main = 190, 195, 210 Pilot = 20, 25, 27.5 Needle = 6F8 So far, I've...

Sorry, no pics....... been stuck with fabbing up a rear brake light and wiring hell. I'll have some by the end of the weekend.

Yeah, it's a bit tricky. I cut short of what I want and then take them to the bench grinder. If you stand the pipe up on the slash cut, you'll see where you need to trim it down. Worked for me. Hope this helps.

You should just ask joewiseguy...... I purchased one of his intakes and he's been more than helpful with questions about the carb setup. I'm sure he'd be glad to help.

I haven't ran the bike yet with them so I don't know. It's not for sound dampening as much. You can google or search the forum for more info........here's one link http://www.nightrider.com/biketech/exhaust.htm :thumbsup:

Right on! Thanks for looking out. Did you run your own wiring on your bike by chance?

That's funny.... "I have custom lollipops in my exhaust!" Can't wait to say that to someone.

I installed mine about 3/4" before the bevel of where it transitions from 1-3/4" to the smaller I.D.

DEI titanium wrap and high-heat paint on tips.

They're bright as F*CK too! I go them from Radiantz.com with a dual element circuit which reduces the brightness for tail and full power for stop. $58 shipped so not bad. They're just under 4 inches in length. Very narrow too.