Recent content by Eotnak

Let it soak in PB Blaster or transmission fluid mixed with mineral spirits overnight. Use compressed air with a wooden block to act as a stopper. I've done this hundreds of times, never a problem. I would use grease method as a last resort...not interested in cleaning that out.

https://www.metric-conversions.org/energy-and-power/foot-pounds-to-newton-meters.htm You mean after the motor work? I would think possibly if the valve adjustments are out of spec, but I would lean more towards that carb/intake setup. I'm by no means a restoration nazi but if you're going to...

It depends on where you reconnect those rear frame tubes and if/where you move the rear shocks. Where are you from? Looks like South America.

Nice, sounds like you're having fun now...how about some pics of those skulls lit up?

Fastenal can ship to Winkler, MB CAN or Grand Forks, ND USA I just sent a quote request, FANTASTIC TIP!! Thanks! Update: $50 plus $185 shipping to Fastenal store at 2703 Valley Circle, Grand Forks ND, 58203

Please note the damage to the fork lock that I just noticed on the frame:

Fedex tells me $26, see pics below. 80 lbs. 51" x 31" x 15" Greyhound: $50 plus $185 but the closest they ship to you seems to be the Greyhound terminal in Moorhead, ND UPS: $50 plus $306 Fedex: $50 plus $282 I think it's too big for USPS no fender but $5 plus shipping for the headlight...

Sorry for the delay, everyone. I had to go out of town on an emergency, I'll get back to you by the end of this week. Tom

4 diodes aka bridge rectifier and a capacitor should do the trick.

Heritage airbox should fit, as far as I know. Better double check with the experts, though. Frame just needs a repaint to be perfect. Just surface rust, perfectly straight from my examinations. Tom

Cleaning out the shed, unless otherwise stated, prices do not include shipping, give me your zip for a quote. Also, if my prices seem off, please let me know...thanks! Special seat: $25 (additional pics available) Heritage air box with clean, fairly new filter: $25 (additional pics available...

Blasted and painted a Honda headlight bucket. Made a seat bracket out of steel stock that was originally holding a door together on the house. More ugly welds. When the kids are behaving I run out to the garage and see what I can do and it starts to really show at times like this. More...

They are unpolished CNC bent pipes. They're not that bad at all, I thought there would be a lot more tooling marks to clean up.

Some more powder coat that was not masked. I swear after all of this the biggest job will be removing all the amateur-job powdercoat. This spot in particular was keeping me from flipping the pegs up. Bending the shifter. I guess I don't have any pics of the kick starter. I tried to heat...