Recent content by kball

Nobody can use any of this stuff? I figured it's the kind of stuff most bikes could use.

The seat cover is for the 75-76 type of seat. It's in perfect shape, just a bit dusty in the pic.

Got a bunch of good stuff after finishing my bike. Hoping to sell as a lot. 72-84 Clutch pull kit and thrust bearing $50 75-81 Gasket set $40 72-84 top end screw kit $40 Bottom end screws $10 70-84 Perf oil filter kit. Like new comes with new gaskets and new oil filter $100 70-76 footpeg...

Never answer anonymous letters. Yogi Berra

Check out my post in the carbs section. I don't bother with sealers either. Once you have the tank clean you shouldn't need it if cared for properly. If it's still crusty inside, you're not done yet.

I'm currently doing a resto on my 75 xs650. I can't say enough about how easy this is and how well it gets the rust out. I had each one hooked up to a 10a charger in parallel with a 12v battery to maintain a steady current. After about 8-10 hours, both tanks were as close to perfect as they'll...

While im in there cleaning up my carbs, should I be getting a diferent pilot or main jet? My engine is stone stock aside from pod filters and a mac 2-2 exhaust. Bike is mainly ridden at sea level. Thanks

pm sent, thanks

Need a pretty clean right side muffler for my all original xs650 as well as a right rear signal assembly. Need to fix these things to qualify for collector plates. Paypal ready.

What year are they from? Was about to order new fork tubes for mine and go through them very soon.