Recent content by keithers273

No collars or spacers, just the wheels themselves. I'll see what shipping cost are "Focus."

The rear is disc which I have as well, no bearings in the rear, I don't recall the front. Oxford mi, 30 min south of Lapeer.

I have a set of front and rear aluminum mag wheels for sale, 19" and 16". Best offer. Need to get rid of them or they're going to the scrap man. Shipping from 48370, Michigan.

I've been searching for this topic but everything relates to dual element bulbs. I have two single element LEDs, just one positive and one ground wire. The led lights are currently wired from a trailer light converter. Turn signal and brake light work properly but when trying to tie in the...

I switched from a mag disc to a drum spoked hub and the spacers do not seem to be right. I've looked at plenty of schematics and have it set up right but I'm just lost. The inside spacer, between the bearings, seems too long not allowing the bearings to set against the seats. Are there...

In motocross, many run standard chains because of the "horsepower issue," if you want to call it that. When the rear tire is spun on the bike on a center stand, you can see the standard chain tire will spin a little more freely under less resistance. I've always ran o-ring chains, they seem to...

Ugh, thanks everyone. Just got a real xs650 brake today. I'll see if I can return the other.

So I got a used rear brake drum off fleabay, http://www.ebay.com/itm/170765875592?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649#ht_500wt_1123 and it doesn't fit. The center of the hub comes out too far and does not let the drum sit flush inside the hub. I'm looking at another one on ebay...

I bought a 16" spoked wheel off ebay from a 74 cb 350 just to use the rim from it. Upon closer inspection, the rim is a Dunlop rim that says made in england. Its a 16x3 36 hole rim. Just curious what it was from, as I'm pretty sure it wasn't from a Honda.

Still in the works but I'm using the stock tank. I cut the back and bottom and increased the bend downward from near the filler neck.

Still looking for a rear brake drum.

I am switching from mags to spokes and have a rear hub. I need a full rear brake setup with pads and the brake lever/rod. I am looking to polish it too so nothing too nasty.

Its good to see the fellow riders from the mitten. It's been a blast working on this so far. Have some bars mocked up, cutting down the tank, lowered the forks, and drilled the rotor.

What would you take for the rear brake? Are the pads good and do you have the linkage arm too? Looking for a 16", but to confirm, that looks like an 18"?

Thanks but i was able to get a 21. Still looking for the hard to find 16" rear. Damn 36 spokes, why couldn't there be 40?