Recent content by Paul75

Got it sorted! Didn't use new washers though, will report back once I have ridden it again.....hopefully no leaks....if it leaks I'll use the washers...

Paul you have too much time on your hands! My little fella was pretty loose too!

Got it, 7ft/lb = 10Nm....

Anyone have the torque for the little fella behind the carbs please?

When re-torquing I guess there is no 'pattern' in which to follow (probably a silly question)....

I'm happy to not worry about the new washers if that's cool because they are a pain in the butt to get hold of..... (thank you Meddy though).....

Ok, the points housing is 100% clean of oil. Oil was definitely coming from that gasket. I have been busy searching the site for info, I found this written by yourself: "I pull the 8 large acorns, one at a time, clean if need be, anti-seize, then torque up to 25. When all 8 have had that done...

Guys I need a little help please!!! Took the XS for it's first short ride yesterday, I noticed a small dribble of oil from the gasket in the photo, just below the plug - which gasket is this? Once I know this I can look to hopefully re-torque, if there is any advice on this would be superb...

Yup that's them.....not ridden with them properly yet but seen fairly decent quality for the price!

Guys I pulled the bowls out and sure enough there was a bit of crap in one of the pilot jets.....fired it up and bingo! Perfect running bike!!! Thanks all....

Good info as always. Ah ha, now I remember, these little flat headed jets are the ones I couldn't get out when I had the carbs apart. I think I ended up blowing them out with carb cleaner. I will try again to remove them with a good fitting ground screwdriver and report back......

Guys Hope you are all well!! Ok so I've been off here for a few weeks....but had to come back because I miss you :-) Now the weather is perking up a little I've been firing up the bike getting ready for a proper test ride. Upon firing it up (from cold) it is running really badly, popping...

Sounds like fun! This thread certainly helped me get mine running like a charm I'm sure yours will in no time too ;-)

Will do.....one think I will need to do is TIG a brace to the numberplate bracket as it vibrates all over the place. Another thing that hit me is how small these are, I'm 6'2" and dwarf it! Kinda reminds me the Harley 48 I had last year. Think this would be suited for short blasts around...

I'm not sure these are made by but they were pretty cheap....Chinese I think......easily found on ebay, I see a lot of the custom bike builders seem to use them.