Recent content by Quoco

hey guys, i just had a quick question...im in the process of working on my chain tensioner and wanted to ask before i go any further. How tight should i tighten the chain tensioner nut? should i tighten the nut until it barley spins or give it a little movement?

hey thanks for the reply guys really great,... ill try reading it again and check back here.

Hey guys, I was wondering if you could give me a helping hand. I spent all afternoon trying to get my 1971 yamaha xs650 to idle right, yet it was a failed process. It would start up evey kick and run yet it has a lot of back firing to go along with it. I try to adjust the mixture screw but it...

Xxxxxxxxxxxxxxxx

Zzzzzzzzzzzz

Zzzzzzzz Zzzzzzzzzz

Hey guys, so I took a few advices and tested my pamco ignition the way it was instructed to do. i spin the rotor with out the pin and got no spark. I checked my coil that was from mike xs that the old owner had on it and the ohms read at 5.7?..that's not good is it? Because Pete said that it...

can anyone tell me if my coil is bed, it has a little drip of oil and i try testing it for some ohmeter but nothing shows up on the volt meter.? any clue

@retiredgentleman, thank you for the help, really means a lot...i will try to figure this out after my midterm studying. again many thanks, if i cant figure it out i will surely as you great group of guys for more advice.

Really? @grepper..when i bought the bike, the pamco came with it install and worked and the bike ran strong...I made the mistake on taking it part and missing up the wiring..how would you know if the pamco is fried? Or bad

Thanks mick71b but I'm still kinda lost

Hola amigo, como esta? Me no hablo es ingles. Como desey mi yamaha motorcycles es no bueno!