Recent content by Randy Robinson

Looks like they’re great tools for the right screws

Ok thanks

Tachometer for a 75 XS

Looks Great!

Will a camshaft from a 1980 fit a1975 XS650? Thanks guys

Hi not sure what’s left. I’m looking for 75 seat latch and fuel cap assembly Thanks

I am leaning towards 2 into 2 It looks more balanced and for tuning. Seen and heard enough of scraping and have experienced it also. Thanks

I looked a little further into the forks and like I thought they are 34mm but what is strange is and you picked it out right away is the location of the caliper. Someone has switched forks for one side to the other and mounted the caliber on the backside and ran the steel brake line around the...

The ownership says it is a 1975 and the forks measure 34mm. I have cleaned up the valve seats,regrounded the valve and lapped them. Cylinders were honed with new rings installed. Swing arm bushings and shaft arrived today as well as steering head bearings and fork springs and seals. Looking...

I just picked up this bike last fall. It was a pretty good find but with any 42 year old there are issues. Bad compression, missing parts and aftermarket exhaust with holes which were repaired by brazing the holes and where the mufflers join the pipes brazed again. I have steering head bearings...

I saw this on kijij I think it was very recent. Thanks for the info.

What exhaust system would you recommend for a 1975 cafe?

Thanks for your replies. Was there any better performance with the Mac 2 into 1 system?

Has anyone used or have a Mac 2 into 1 exhaust system? I would like to have some feedback about this product. I’m building a cafe Bike and I’m looking for a exhaust Thanks Randy