Recent content by rider119

  1. R

    Too much chop?

    Is removing the gusset on the backbone a no no?
  2. R

    Too much chop?

    I'm 6'3" as well so I'm concerned with the ridability of the bike for me. Nice bikes, but I'm looking at putting the front of the seat rails further down, below the gusset that is on the curve of the backbone of the frame.
  3. R

    Too much chop?

    Anyone have pics of something similar that's been done?
  4. R

    Too much chop?

    Kinda wanting to do a drop seat'ish brat bike but not sure, opinions? New seat rails at the tape line?
  5. R

    Making some progress!

    Because they won't let me post without atleast 8 characters you just wasted 10sec of your life reading this...
  6. R

    Making some progress!

    Trying to figure out how I want to chop it
  7. R

    Leaking petcock

    Yes, it has the vacuum barb on the backside. I'm assuming the mikesxs ones don't?
  8. R

    Leaking petcock

    Mine has reserve, prime, and on, maybe it's not original?
  9. R

    lane splitting?

    Yes, but only if you're on a Harley.
  10. R

    Leaking petcock

    Stock tank and petcock, gas leaks out of the little channel in the plastic part of the petcock. Can I just plug that with some yamabond or something?
  11. R

    Electrolysis

    Maybe the electrode would still need to "float" inside the tank?
  12. R

    Electrolysis

    Could you just submerge your entire tank in a tub full of water and cleaning soda, connect a wire to the tank for the charger ground, drop the "electrode" in the tub and get the inside and outside cleaned?
  13. R

    Pamco Pete needs your thoughts and prayers

    Thoughts and prayers Pete's way, remember, through Christ all things are possible.
  14. R

    Wanted - Advance mech plate

    Looking for a good used oem mech advance plate.
  15. R

    Advance mech plate replacement?

    How much do good used advance plates usually sell for?
Back
Top