Recent content by riv

lol , trust me buddy there was a lot of blood sweat and tears just to get it ticking over if i was any good a typing i would write a book on stuff ive done . cost me a fortune just inside the engine . ive only been able to attempt something like this through the knowledge on this site . i may...

so far , keeps me out of trouble lovin this xs hobby .

man thats one dirty bitch love it

nice . giz a go lol

think i would start uping pilot jet first but im no guru but that worked for me

hi bud , i fitted a 2 into 1 . had problems running lean had to go for a small cut away on throttle slide down to a 2 from a 3.5 amal 930 carb but it may be my strait through pipes . pancake filter works nice on mine

even got a key now

prob going to put red leather under laces . still no clue what im doing but having fun. if i ever finish it i will be lost me and my shed have become great friends

took her out for a her first ride, fekin great day . rides great sounds great just need to work on her now for the rest of my life making her pretty . o and spot the difference game still going.

back wheel and foot pegs are optional extras

amal 930 premier

yes mate single amal 930 with a manifold from greensand foundry

rotor fits on with a tapered hole rather than a key . I think that it was not machined properly and did not fit down the spline far enough to cover coils on stator plate so I put washers under coils on stator to push further in so magnet covered coils more. hope this helps any one else using...

found problem dam elllectrex world rotor not over coils enough . put a couple of washers under coils to push them further in the rotor starts great now . ive even taken her a ride round the block a few times lovin it