Recent content by roadstar06

  1. roadstar06

    Comment by 'roadstar06' in media 'Tanner's XS650'

    alot of reading ahead of you- you tube!!! Hughes Handbuilt!!-Good luck
  2. roadstar06

    Carb jetting

    I had to order #20 jet and 190 main and it runs fine now still a bit rich but idles nice and no popping- its going to take some time but just keep changing them till you find the right set up. 3rd slot on needle also double check throttle cable!! so slides are all the way down.
  3. roadstar06

    What have you done to your XS today?

    put right side case back on after replacing washers that go behind clutch basket- guess what she's a runner now, very happy to say it took it down the block today for the first ride.
  4. roadstar06

    For Sale - Xs650 Parts

    any titles?
  5. roadstar06

    For Sale - Titled Neck

    how bout 100??
  6. roadstar06

    OK, I', stumped

    ok, I managed to get #3 spacer off today, pulled out 2mm washer and 1mm washer-1mm washer has broken and according to pic in earlier post its incorrect as well, same O/D as 2mm and same I/D as #5 in pic. #3 spacer is very tight going on shaft-2mm has battle scars- Q: is there supposed to be a...
  7. roadstar06

    OK, I', stumped

    I will attempt to get some pics of my workings ,maybe you guys will notice something out of the ordinary- that's if I can get #3 spacer off !! I tried the other day and gave up after 45 minutes (no heat used) I can get it to turn slightly but no fwd movement yet- going out now-check back with...
  8. roadstar06

    OK, I', stumped

    don't know how that could seize but I guess anything is possible, will try heat today see what happens, thanks
  9. roadstar06

    Yamaha XS650 Experimental Clutch

    very interesting read, I think we're ready to go to Mars with this clutch now, why didn't these genius at Yamaha figure this stuff out when they built 1st. motor? the springs in my flywheel or flexplate behind hub are not all equal pressure, could this be a factor of clutch non-disengagment...
  10. roadstar06

    OK, I', stumped

    #3
  11. roadstar06

    OK, I', stumped

    hub spacer w/ spiral oil passage
  12. roadstar06

    OK, I', stumped

    Hi 2m-yes it moves the same as in video #1 , has at least 2mm of movement when lever is pulled- with bike running put into 1st. will give it gas, bike tries to roll but stalls- tried to break loose with front tire up against work bench gave it lots of rpm holding clutch lever in put in 1st crack...
  13. roadstar06

    OK, I', stumped

    correct yes narrow then fat one,thanks
  14. roadstar06

    OK, I', stumped

    thats a pretty big turkey baster..lol- ty by btw for the info on the vm's . worked out great
  15. roadstar06

    OK, I', stumped

    yes it does and yes they are lined up-thanks
Back
Top