Recent content by Sazbo

Thanks

Thais for the info guys

Hello all, just wondering, is Slingshot Cycles still around, I'm looking for a one piece front ss brake line for my 75.

thanks guys

i shortened the wire on one side of my E-Advancer by like 3" will that mess it up, and how close is too close to have the e-advancer to the coil. Thanks

Forgive me if this info is out there, I've been searching but can't seem to find much. Can an antigravity 8cell work with a pma, will it charge correctly?

yes, my question exexactly, looked at it with just short of a electron microscope, no markings anywhere.just got a response back from Mikes, they said the manufacturer doesn't mark them, strange.hope they never mix up there parts bins

hi all, got a needle jet from mikesxs but it has no markings on it, so do I have to trust that I received the correct one or is there a way I can make sure it's what I need, can I measure it somehow? I don't get how there is no size stamped on it.

Free new IZUMI Rear Drive Chain - Heavy Duty 530 x 104, why free, just like to give back to a community that's given me so much. PM me if you need it.

carbs are sold.

Two rights, supposedly for 4 stroke, not sure about anything else.

(2) VM34-168 carbs, new in box. Make reasonable offer.

Thanks guys, another thing I'm wondering about is, I want to replace my fork springs, I figure I mine as well they are the originals. Mikesxs has the progressive type, would these be ok to use with Hughs lowering kit or do I stick with stock springs.

Hi all, i can't seem to find a difinitive answer to this question, maybe there is none, well here goes, Is there a rule of thumb when lowering you fork. If my rear shocks are an inch shorter do I lower my fork an inch, or am I not thinking about this the right way.

Thanks 5twins, so i guess i'll leave the adjuster all the way out on the initial start and then adjust from there.