Shaft collar 341-25183-00-00 or 90 387 - 17433-00

Lassesand

Lassesand
Messages
5
Reaction score
1
Points
3
Location
Sweden
My 447 is missing the shaft collar listed above. Can anyone provide me with the correct outer diameter and width? I did find one from an XS500 that wad 28 mm OD and 20 mm width but it was in a box of parts that I didn't need (70$). ImageUploadedByTapatalk1430633872.882866.jpg
 
That appears to be the rear axle. That is the spacer on the drive side. The collar is just a stamped steel piece that is a press fit on the spacer. They are listed as separate parts in the fiches, but hardly ever found alone.
On some of the parts sellers they have a parts look up with fiches, some have a p-lace you can put in the part number and tells all the bikes that used that part number.
All those drive side spacers were the same from 74 up. So it shouldn't be hard to find.
Leo
 
It's the front axle. It's the spacer I need. The collar is of less importance. Everywhere I look it's discontinued. I just need the dimensions.
 
It's the front axle. It's the spacer I need. The collar is of less importance. Everywhere I look it's discontinued. I just need the dimensions.

Hi Lassesand,
if nobody posts the dimensions, you can make measurements.
The spacer bore has to be 17mm.
The spacer outside diameter has to fit inside the seal in the hub and the spacer's length can be found by putting the wheel into the forks and measuring the gap that it needs to fit in.
A plain old cylinder will work if you don't want to bother with the pressed-on shield.
 
I'll get you some measurements this evening(couple of hours).

I didn't remove the dust shield. I used dial calipers not digital and my eyes aren't good.
But here ya go.
17mm ID
20mm total length
28mm on the fat side for 11mm
27mm on the skinny side for the rest of the length which I am assuming would be 9mm.
 
Last edited:
I doubt you will find a new one, the bike is 30+ years old. I might suggest putting a parts wanted add in the Classified of this site. Or some one who reads this thread might have one you can get.
I find a lot of stuff like that on Ebay. Try shopping there.
Leo
 
Back
Top