Giveaway: Chop Source Frame Jig Kit! (ends 11pm CDT on May 14th, 2017)

Travis

Forum Staff
Top Contributor
XS650.com Supporter
Messages
4,533
Reaction score
1,493
Points
163
Location
Roberts, WI, USA
Update 5/15/17:

And the lucky winner is.......

Post 11, Jeepert88

Congratulations!

Everyone else will be receiving a discount code good through May 31st for 15% off everything on www.chopsource.com! Thanks for playing!


Giveaway: Chop Source Frame Jig Kit! (ends 11pm CDT on May 14th, 2017)


Chop Source is giving away another frame jig for the third year in a row! Same rules as the last two times.

frame_jig_giveaway_2017_xs650.jpg


Win a Chop Source Frame Jig Kit!

To enter the drawing just post in this thread! Existing Members Only! You need to have been a registered member before the date and time of this post to be eligible (this will be verified). All entries from members who joined after this post will be ignored. If you are new to the site, register today to be eligible for future member only drawings on XS650.com.

One entry per person (only the first post by each person in the thread will count). You must post before 11pm CDT on 5/14/17 to qualify. The winner will be chosen randomly from the qualified entries. Shipping will be covered by Chop Source within the U.S. (members located outside of the United States will receive a $21.50 shipping credit). Winner may also choose to receive a $321.45 store credit ($299.95 frame jig + $21.50 shipping) to configure their frame jig with other fixtures and options. International shipping is expensive because the parts are heavy (up to $186.85 for the frame jig as shown above depending on where you live). Use the shipping calculator on chopsource.com at checkout to determine how much shipping will be before you decide to enter the drawing.

The Full Frame Jig Kit includes all of the fixtures and hardware you need to get your table-top frame jig started. You need to supply about 21.5' of 2"x3" or 2"x2" tubing (1/8" wall) for the the jig. The frame jig kit bolts together so you can break it down and store it easily when you aren't using it. No drilling or welding required except for the feet. The neck fixture will accommodate rakes from 15 degrees to 60 degrees.

You will receive the following:
- Neck Fixture
- Axle Plate Fixture
- Two Base Clamps
- 1018 Mild Steel Neck Cones
- Feet Kit
- Adjustable Width Fixture (shown) or Internal Center Fixture
- 3/4" Threaded Rods and Spacers (shown)

Chop Source Full Frame Jig Kit - $299.95 value

For complete details of the Chop Source Motorcycle Frame Jig Kit or to view assembly instructions visit www.ChopSource.com


Good Luck!
 
Last edited:
This would be AMAZING!!!! I am FINALLY getting a chance to build my first XS bobber after 6 years of dreaming about it . . . Winning this jig would be a dream come true!!!
 
Back
Top