Pamco Advance Box - Failures?

Maddog2201

XS650 Enthusiast
Messages
30
Reaction score
12
Points
8
Location
QLD
Anyone had a Pamco Auto-Advance fail on them? Mine did a while back but it was just a wire broken off the board so I soldered it back on, good as new. Kind of makes me wonder why there isn't some glue or something over the joint to stop it moving.
 
The regular pamco looks fragile to me there, too. First thing I would do is put on a blob of hot melt glue or Amazing Goop on the joint to keep the wire from vibrating at the joint, where it will be brittle from soaking up solder. This is the first complaint I've seen on here of it breaking though.
 
Last edited:
True, for now I've just fed some extra wire in the box and externally heavily taped the wires down, in going to assume that this happened because I was rebuilding the loom just prior and moving it a lot. If it happens again I'll glue it down though
 
Back
Top