Help ID part please

FatChance

XS650 Enthusiast
Messages
44
Reaction score
55
Points
18
Location
Wi
Found this after pulling off my clutch cover. Is it the clip that goes at the end of the kick start shaft? I did pull that out by accident removing the cover. I have the Clymer manual and it looks like one piece in the manual. Did I break it.

AC0AF837-4913-483E-BC78-655C1A75008A.jpeg
 
#7 maybe
john

Could be #7 John - but the edges of the two little segments look like they've been sheared off.

Of course, if they have taken a ride around the primary gears a few times then having them look a wee tad chewed up would not be a huge surprise.
 
Last edited:
Hmmmm...I think you might be right about #7 John. Those do look pretty semi-circular.

...of course, my old-@ss eyes may also be playing tricks!
 
I have another contender to look at tonight, the washer plate at the bottom of the tach gear.

97F380A5-3C4B-4142-B35E-4B5ECB637570.jpeg

I also noticed on the kickstarter shaft the washer plate that was installed on the outside of the circlip. The diagram shows the plate to be on the inside of the circlip.
 
Last edited:
Back
Top