Bought these for a 650.
Have a yamaha brand on the rear hub.
I am putting together an old special that is a mix of old parts.
I have a Pamco installed and
I cobbled together a PMA.
Could someone give me an idea on what jets I need.
I have a pair of unlinked 38s that came with my 1980 special roller.
The engine has been...
What is the most basic wiring system to run an engine with.
Original charging system.
I have all of the...
Another Throttle question.
Currently I have a Motion Pro Throttle assembly running a CB350 2-1 cable into unlinked BS38s, as I saw someone...
Did I see somewhere that you can remove the plastic reservoir from this Master cylinder.
I wanted to strip it and paint for a rebuild.
Item #8 in this schematic.
Is it a bush that fits inside the lower engine case.
Or a type of washer that sits on top of that hole in the lower...
Have started to educate myself about these carbs, They are off another roller/wreck I bought.
Unfortunately the PO has given them some abuse....
Can someone give me a mudmap on how to plumb a set of unlinked bs38 cv's.
Im using a single non vacuum petcock.
Getting close to igniting the...
Need the 3 small Phillips head screws that hold the seal mount to cap spring.
Anyone have a size or thread pitch.
I have converted the disc rear on my 79 special to drum rear.
Is it possible to use the Disc brake pivot shaft as opposed to the drum.
Just put some new Bronze bushings in my swingarm
trying to fit a swingarm tube that has only been fitted once before,
But I fear I may have been...
For the life of me I don't know how this seal fits on this cap.
Is this right?.[ATTACH][ATTACH] [ATTACH][ATTACH]
Purchased a downward off eBay.
Read on the web about some guy welding up the gaps in the plate near the pivot.
Got the local fab shop to weld it...
Just changed my headstem bearings and races with the SSY500 bearings from the usual supplier.
Is it true these bearings are a little higher ie...
Purchased these off fleabay for my 650 build. These were linked carbs advertised as X650.
I bought these to substitute for my bs38cv individual...
Will a 19inch front wheel fit on a 1980 special with original front guard??
Is this a "special" cap or earlier.
What size are the 3 small screws.
What is the correct seal.
Currently using Toyota Camry thermostat seal...
Lost the 3 screws in pix.
Anybody know what size.
These are the carbs came with my roller wreck.(already stripped and cleaned)
I guess its an Aussie 79 special.
Do these carbs normally use a 2-1...
Separate names with a comma.