Left side tight, clutch feels fine. Nice to get the left pegs on too.
Soon, BS38'S :)
:lmao: "Patina" in Irish terms is like..
"its as shiny as me ol tooth"
Figured that other excuse to not polish might get noticed by Mailman Bob...
Do you have a hot air gun? Hair dryer?
Maybe some heat and a drop of light oil on top of the nuts/adjuster threads and those may just snap loose....
5twins did mention that actuator hole casting blemish? And yes, this did need to be addressed. I just carved the seen lip off...
Back to routing the Stator harness behind the front chain guide.
Altered and Strengthened the chain guide itself with Vice grips.
Spaced the rear...
:laughing: So sorry, couldn't stop myself again
Chet ironhorse, pm'd pics to you.
I know a guy who knows a guy lol. Actually, I can pm a pic after 5:30 Pacific time.
:agree: off road electric stealth and power does interest me
"rattle can" right on takehikes. Well done
Nope, Stone tools last as long as the rocks they were made of. All else goes away eventually.
Our scientists can all try to debate the age of the...
Very disappointing to see the loss. Googling the fire incident doesn't provide much information but I would guess because of the high location and...
Black / Gold like these?;)
220 miles from home we found an "limited but open" Burger Pub :)
Was so very fun to actually sit in a restaurant (door open) and...
Your jetting will depend largely on the exhaust system in the end. I try to run bikes on the lean side, combined with precise ignition settings....
One up on main jets, one up on pilot jets is a fine place to start. (guess) on 78-79 series BS38'S with UNI Pods..
Lookin So fine! Take all the time you like.
Have you seen a "single outlet crankcase breather" from an 80 up engine?
Two clutch choices to make before that left cover goes on.
I can choose the newer clutch actuator which has the cable anchor in a...
:rolleyes: Ace hardware lol. "Satin" sprays on easy and kinda hides un noticed as to being just a easy touch up.
But I'm cheap and lazy...
Let the rotor/ stator run awhile longer. Watch and Confirm the charging system again.
Good luck doing carburetor tinkering !
Separate names with a comma.