Search results

I have a 78 special roller, it’s a little rough, but tested 120 psi on compression & shows a little over 8K on the odometer. I’m traveling to Birmingham Al in a couple weeks.

Thanks DogBunny!

Need a working horn for a 74 or 75 TX650A or XS650B. TIA

Hub only decent bearings. $40 + shipping.

I have three swing arms, all are for drum brake. 1 stock, 1 extended 11/2”, and 1 that’s been braced bottom side. $20 each, you pay shipping.

I have one I never used. $75 shipped.

They look like Yamaha R1/R6 calipers.

Would like to find bits for impact driver!

Bump

Is it from a standard or special? I need one for a 75.

10 3/4” Bobber shocks new. $60 shipped.

Sold.

HHB Speedster pipes. Never used so getting rid of excess parts. Raw finish with hardware-$200 OBO shipped

How much for the drum rear mag?

You’re right Gary, The exhaust and breather cover are quite thick, the intakes are slightly thinner. I started to tighten them down, but there is really no need. Just enough to put a little crush on the O ring. I had no leaks at all using a power washer.

I was getting ready to power wash an engine out of the frame, my grandson 3D printed these for me. They work great, reusable, and are great for storage as well. I had the breather off, so he printed one for that as well. You only need to snug them up enough to put a little crush on the O...

Does the rephase help at all ? If so, why don't the manufacturers do it ? They do it now. All the new Yamaha twins, Triumph’s have 270* phasing of the crank throws now. Triumph only had it on their Scrambler previously.

I remember reading of someone who did this some years back, 750cc twingle, he put it on a dyno & it put out something like 90 ft. lb. of torque. Better weld the crank, I’m sure it would be a great hill climber, but a horrible street bike.

Thanks for all your hard work documenting this. I have both 74 & 75 gauges Im re-doing. On the 74 I used a TX 500 bracket since Im just refurbishing, repainted and re-labeled the face since the the 500 had an oil light where brake lining light goes. The 75 Im trying to get original, & this is...

Is this what you are needing? Its held on with two small acorn nuts.