Search results

Header pipes, rear caliper bracket, front right side caliper brackets, rear brake pedal for xs650. Other misc. items;chrome Harley master cylinder, sportster foot pegs and brackets. Also soft tail seat some passenger pads and gel pads. Send me an offer.

So out to the garage I went. I replaced the nylon screws with the metal ones. I disconnected the black brush wire coming form the alt. and left green to the green brush and connected brown to power after switch. Now what do I connect the black wire from the other brush to? I had it running with...

Ok so out to the garage later and on to making a few changes and see if we can get this rascal going. Thanks

Using the wiring I posted above I ungrounded brushes and my brown connects to the black from my brush. Leo are you saying my black should go to ground with a solid state unit?

My motor is a 76 with green wire to the outside brush and black to the inside brush. Wiring from scratch using wiring drawing posted above. I have the brush holders in the top picture.

Which brush is positive right or left? When I check with meter running I have battery voltage on right and less on left.

Had grounded no change I am thinking bad unit also just hoping for something else. Thanks

Ungroud brushes otherwise stock

Here is the diagram I used inserting the solid state rec/reg in place of the split unit.

New unit from company on ebay. Stock points system.

I have the green going to one brush and I disconnected it then took it to ground.Just for a moment to test for increased voltage with increased rpms. The red wire feeds the points and the battery through a switch. I am not using mikes but a unit that is supposed to be for a points system.

Ok so I have a 1976 motor that I am using a solid state rectifier/regulator with my stock points system. The first one would not charge battery. Jumped green wire from alt to ground and voltage increased with rpms. So I bought new rectifier and went over wiring for the umpteenth time and had...

No I haven't

Need a shift rod threaded on each end ( left hand and right hand) about 9 " long to connect my shift foot controls. 6 mm diameter

PM sent on caliper

Right front brake caliper?

I have a 1976 xs with points I installed a solid state reg/rec for points I bought from someone that said it was good, however I was getting no increase in output to battery with increased rpms but did when I jumped green wire to ground. So I bought a new unit and am still not getting an...

Front brake caliper?

front fender?

I just got my 76 xs650 together and set the timing as instructed. Using my timing light at idle the marks are almost right on however as I am watching the mark on the stator moves back and forth just slightly. Is this normal or should I look for something else?