Search results

What are you guys using? do many dirtbike master cylinders fit the bill? I noticed theres a local one for sale for a cr125 seems like it would work does anyone know?

Theres way to many small parts that need to be hand made and alot of labor that needs to be put in the bike that would be impossible for a computer to estimate because depending on your skill and available tools it could take forever if you just want a parts cost come up with a list of...

Dont buy any parts unless you have to just clean all passage ways and blow them out with compressed air after the carb clean

I rather buy xs parts from mikes then hunting them down from a bunch of other places

hey tech what part of NH are you in? I notice teebs is in the area too do you guys get together for any of the local rally's like bike week?

yeah it has springs you should be able to see them in the pic its not bad as far as comfort goes at the moment but it just feels like it should have some lean forward to it

yeah it was removed it was only tacked on and my buddy welded the tubes then the seat pivot on. now i'd like to put a small plate across the tubes and bring it down a little to tilt my seat forward a bit... the back is level with the ground so theres nothing holding my ass in place when...

I have a dewalt angle grinder that I used to take all my brackets and extra crap I didn't need off the frame it worked flawless and very quickly. I used a cut off wheel or sometimes the grinding wheel to cut the brackets close to the frame then grinded them a little closer switched over to a...

big in which way? tall or to long? the back of the tank sweeps in its a half round like the front so the rear tire can slide right up in I might have to move it back a little for the desired look

I doubt it looked good from any angle

what about the original chain that came with the xs? keyed the same as the ignition bad ass if you ask me

whats going on with the rear end? its not hardtail or if it is my fat ass couldn't ride it.

on the bike as a whole?

Well i'll get to the store and pick up some regular wire and get rid of this core wire stuff sounds like its much better thanks for the input guys i'll let you know the results

New additions to build. Painted frame and engine cleaned up rims re mounted engine. Made headlight mount, mounted seat springs to frame. My original rear fender idea was to cut down a trailer fender from tractor supply but it was still to big so i cleaned up the front and am going to use it as...

just have a buddy dump a 5 gallon bucket down the pipe while your in the basement you should be able to tell if its coming from a joint then. using a hose by its self to test the pipe might not yield correct results. also you should have a cap on it anyway as stated already

I have a general question about welders since you guys know what your talking about. I have a miller 130xp 120v mig welder I tried welding some pipe and metal together and it just spits spatters and makes a mess. its ok for tacking things but other then that I don't know... I got to use some...

Electrician and HVAC service tech got my Electrical license but they don't make enough coin so I started doing HVAC service work...

yellow? is there paint on the pipe? =P

are you still getting any gas leaking? around or out of the carbs? do you shut the petcock off when you park the bike? A air leak is often the cause of the idle staying high. Start the bike and simply spray starter fluid or carb cleaner around the area where the carbs meet the engine if the...