Search results

  1. C

    Giveaway: Chop Source Frame Jig Kit! (ends 11pm CST on March 8th, 2015)

    Gimme gimme! Please? :thumbsup::thumbsup: Posted via Mobile
  2. C

    Miswired pamco ignition sensor?????

    I'm purchasing a new advancer. I hope this works and not 100$ wasted. Posted via Mobile
  3. C

    Miswired pamco ignition sensor?????

    I wasn't sure if y'all would see this unless I quoted... Posted via Mobile
  4. C

    Miswired pamco ignition sensor?????

    Ok. I corrected the wiring issue. I have 5 volts to the sensor and 12.3 at the coil. Still no spark!:wtf: I removed the block that ties in the locating pin to test the sensor with out cranking it over. I get .4V on the green wire on the sensor when the magnet passes over but 0 going to the coil...
  5. C

    Miswired pamco ignition sensor?????

    Thanks pete! Looks like I wired the advancer backwards! I took the cap off when I got it to check the board for damage as a precaution. Apparently I wasn't too mindful of the orientation of the cover! I think I'll mark the leads this time!! I'll rewire tomorrow and give a report back! Thanks...
  6. C

    Miswired pamco ignition sensor?????

    So I just finished installing my pamco ignition. I have no spark whatsoever. I noticed that the sensor itself seems to be wired incorrectly. The three leads soldered into the board on the sensor are red green and black. The board is also labeled this way. BUT the red and green are reversed. Can...
    • CoronaXS
    • Thread
    • pamco e-advance pamco ignition pamco trouble shooting
    • Replies: 7
    • Forum: The Garage
Back
Top