Search results

Hey guys, im wondering if its possible to lace an iron head 18 inch wheel with an early evo 40 spoke hub? Going to change the 16 inch wheel on the sporty.

so i been having a carb problem lately and finally figured out that the outer shaft seal on the right carb was leaking. went and got new o rings from yamaha and replaced the seals. bike starts up idles good. bike warms up and i go to sync the carbs, adjust idle mixture. same symptoms as before...

So im in the process of making a 2into2 exhaust and im having trouble trying to fabricate. what angles do i cut the tubing. i was gonna break the exhaust into two pieces. one piece coming from the exhaust port and cut before the second bend (one that goes under rh cover). The second piece is...

I'm looking to install wheel hub caps on mag wheels but I'm not quite sure on how to install them. I was thinking of running long bolts from one cap to the other and sandwiching them together with a nut. If anyone has any other ideas, Id like to hear them!

anybody have a float bowl for a 79 xs650 (bs38)?

So today I started to use my 110v mig /flux welder. i wanted to practice laying down some bead and just get a general idea of welding. Im using .030 flux core wire and layed some bead on a some thick steel plates. What do you guys think? Any advice to get nicer welds? (i know gas welding...

im not sure if my coils are bad or not but here are the figures i've obtained primaries for both coil were at 4.5ohms for the secodaries one was 8.52 and the other was 8.92 also when i put the meter to its highest ohm rating and touch one lead to the primary and the other the the mount i get...

Does anyone have a a throttle shaft for a 1979 xs650sf bs38 carb. I believe its the right. Butterfly is not needed but if you have it i'll take it as well. Thanks!