Search results

I've finally gotten my 78 off the table of doom yesterday. While it was on it i replaced the clutch, cable, lever, clutch push rod with a one piece, worm gear assembly. After adjusting the clutch took it for a spin around the block and it won't shift higher than second gear. Any suggestions??

I've been making a lot of changes to my 78 recently. I just replaced the clutch, cable, lever, rod, and the adjuster on the left side. I still have not added oil. I've been working on new forward controls and I just noticed that I can move the tranny into 1st and neutral but it will not go into...

my bobber has used a modified Yamaha shift lever connected to my forward controls. I want to use a Harley set I have that positions the rod under instead of above like with my current set up. where do you get the shift lever from in order to do this?

For those of us that have a single outlet breather, if you want a molded thin wall hose to connect a filter I have an answer for you. Use a breather tube from a Briggs and Stratton vanguard engine. Its part number 806083s. I do maintenance at a golf course and these engines are used in a lot of...

I just got a single outlet breather but was wondering if it is supposed to have the perforated screen like the dual outlet breathers have?

Right after I posted that I looked on ebay and they had single outlet breathers. First time ive ever seen them on there. I bid on one that says its from a 79. pricey, but I want it so its only money right??

I realize im asking about something that's 5 years old but where can you get a single tube breather from that mounts to the old 2 tube breather spot?

is there a wiring diagram in here that shows the set up for a bike with a battery, pma, Pamco ignition, headlight, taillight, and electric start? or one that has kick only?

I'm replacing the top engine mount on my bobber with a 78 engine due to the original mount tab breaking off the frame. I wanted to go with the one piece mount but on my bike the rear part of the one piece doesn't clear the frame. Does anyone know of a one piece mount that has only a single mount...

Hi Pete, I ordered a plate from Pamco but i'm not sure if it is the right one or not here is what is on my bike now. Is the one I ordered correct or do I need to also order the e- advancer?

Thanks Pete! is there any way to identify which system I have?

I bought my bobber with a Pamco system already installed. I recently left the key on by mistake and fried the coil. I replaced it and still won't start. Can you test this system for spark with an inline tester? If the coil fried what else may have too? Is there a way to identify which Pamco...