Search results

  1. Byarchie

    When to re torque a cylinder head

    When should the cylinder head be re torqued after a rebuild please
  2. Byarchie

    Rattling Brake Pads on std 76 xs650c

    Hi has anyone come across this problem. i have twin discs and from the moment i start it the pads rattle in the calipers from tickover and on the move. The calipers have been rebuilt and have new lines with ebc pads in. If i just touch the brake lever it all goes away and is temporarily bliss...
  3. Byarchie

    xs650c Clutch Spring Bolt Dilema

    Hi everyone. I upgraded the clutch thrust bearing yesterday and noticed two clutch bolts were binding inside the springs when doing up. Back apart and measured them up i had 4 with a shaft o/d of 10.5mm and 2 that were 11.5mm o/d. The springs have a i/d of 11.5mm. Thinking 2 were wrong i turned...
  4. Byarchie

    Norton Commando Peashooter Silencers/ Mufflers

    Hi everyone. I am fitting a pair of these to my 76c 650 as my pipes have rotted out. Wondered if anyone has had experience of jetting up for them. I am using std air filters, std headers, bs38s and currently std jets 122.5 main, 25 pilot and 4mi needle. A good starting point would be great i...
  5. Byarchie

    76c xs650 flat spot driving me mad

    I have a flat spot at 4-4.5 rpm I can't cure. It has std carb and airbox setup. Carbs are clean air filters and rubbers are new. It revs cleanly on the stand but won't under load in the above rev range.You can slip the clutch and go through it and it's ok on the other side. Tried putting the...
Back
Top