Search results

Sale pending to gggGary

What ya see is what ya get :)

All parts are stock off a 72’ Except for the Master cyclinder and brake line. Make an offer

For sale 1972 seat. No tears or rips. No mounting hardware. 100 shipped

Sold

I believe so, but I am not 100%

Good afternoon gents. For sale is this aftermarket 2-1 exhaust. It came on the bike when the bike was purchased new in Salt Lake City back in 72' has some heat discoloration and a few scrapes but overall a nice piece. 100 OBO

Sorry MaxPete... already have plans for tomorrow. does these event happen every year?

Installed brembo caliper and HHB fork brace

Bummer I was hoping that I could bolt a different disc to the rotor assembly.

good afternoon gents. I am getting ready to install a brembo kit but was curious if there were any good aftermarket options for a 72'. I know a lot of guys run the xs1100 on the later fork but I wasn't sure if they would work on my 34mm setup. Thanks Lance

I totally agree with 5twins in regards to getting parts right from Yamaha. I spent a full year chasing down an issue, spend hundreds trying to resolve. It ended up being a poor replacement par for my choke.

I believe they do. Price but appears to be amazing stuff. They recently did an XS that was perfect. https://cognitomoto.com/

I wish you luck. Mine fried after 300 miles and I followed the instructions. People will tell you to add a fuse even though there was no mention of it in the instructions. I sent three pms and two emails and my 4 month old pamco warrant parts were not replaced. I ended up buying another...

Today I lowered the 72' front end

Good afternoon Gents! I have had a failed Pamco unit and I have been trying to get resolved for nearly a month. About a week in pete told me to PM my address for replacement but that was well over two weeks ago and no replacement parts have shown up. I have PM twice and tried emailing...

Thanks for the diagram. The major difference is the fuse. What type of fuse holder are most of you using?

Well it has been a couple of weeks and no replacement parts. I have ordered a new plate and perhaps that will show up soon. When it does I will keep yal in the loop. I would appreciate someone confirming my wiring setup in the previous post.

Pete, Could you confirm my wiring in my post above. I want to make sure I have it right.

Yes I am grateful but I don't see where I wired it wrong? No mention of additional fuses in the instructions. http://www.yamahaxs650.com/installation.htm