Search results

I have done alot of fi and the only real sensors you need to make it work are map manifold air pressure iat inlet air temp water temp in this case oil temp for cold start up crank position sensor throttle position sensor o2 sensor From what I see it would be very easy to do a two into one...

I always go to far I guess here is a 1/36 scale truck that will run over 40mph.

Here is my Malibu I had. All GN drivetrain that made 575hp to the ground and you dont how many people would ask me what size big block I had.

Here is the buick I built ground up 355 turbo v8 overdrive trans and 3.08 gears. The car ran 10.03 at 140 on radials pump gas and off the foot brake. You should see the look on a bikers face when you out run them on the interstate.

I will get some better pictures before the tear down which is getting pretty close now. This has been a change going from 800+hp cars to these. I still have alot to learn about them but Im on my way.

New to the site and the sx. I must say they are a cool looking bike and I have put a few hours into it the past month or so. So far it has a tc rear section, forward controlls, fake oil tank for the electronics. I have also added some new exhaust and some new hand controlls to clean every thing...