Search results

This is my bobber project. I just don't have time for it. Stuff is starting to pile around it. I would rather have it go to someone else. I have fabricated some parts for it. Such as a seat, rear fender, jockey shift, foot clutch, foot pegs and a small sissy. The front tubes are stretched and it...

Complete xs650 for sale I'm in the sd area. Would be a great bike to build I have to many I need to get rid of some bikes. I am asking 500 for the bike. I also have a complete bike that is taken apart. If someone wanted to put it back together they could. I want 300 for it. Can call or text me...

I am working on adjusting the air mixture screws. Doing the dead cylinder method, Anyway I turn the mix screw makes no difference in idle. I am assuming something is clogged in the pilot curcuit? Or what else could it be?

I just got done rebuilding some different carbs for my bike. I can tell that the carbs are out of sync. I have made a manometer. Do you adjust the mix screws before you sync or after.

I have been battleing tuning my carbs for awhile now. I jetted up on my pilot jets last night. 42.5 to 45 137.5 on mains. I started the bike alittle hard starting, popped every now an then. Raise rpms to around 1500 to get ready for adjustments did the dead cylinder trick. But the bike would...

I have read the carb bible a few times over. I have a question, under post 5 section 2. It talks about adjusting the mix screws. It says to warm bike up, then set the throttle stop to 1500. Then it goes through all the dead cylinder stuff... Then it says to lower the idle till its lowest steady...

I am rebuilding the carbs on my 80 Xs650. All the research that I have done tells me that I have bs34 carbs. I tear them apart pull all the jets and what not clean everything well , decide to go with the dyno jet kit from mikes xs. It comes and I find that the pilot jets that came with kit are...