Search results

I had just rebuilt my motor last summer. At 50 miles and then again at 500 miles I had found small microscoptic aluminum chips in the filter. Super small but a lot. I had checked the clutch to make sure it was installed and spaced out as it should be. (It was). I had just removed the head...

I had just finished building the motor and finally got to ride it this week. I had just put 50 miles on it to break it in but while doing this i noticed im having a problem in the clutch/trans. It is very diffacult to find neutral when the motor is off. I can find it move the bike a little...

The bike is a rebuild stock bore 650. New piston rings. It has K&n open pod filters as well as pandemonium's yo momma free flowing open exhaust. I am running the stock bs34's carbs. Can anyone give me a good starting point for tuneing this motor. I have only done one heat cycle and only...

I have already connected the masterlink on the cam chain before I put the cam under the chain. I have tried torquing the head and jugs down with a couple ft-lbs and without the bearings installed. I am still unsuccesfull in trying to slide my Shell #1 cam under the chain. Does anyone have...

I have my whole motor torn down and getting ready to put it back together hopefully soon but i took a look at my cam today. I can see it has a nasty lip on it, is it still useable or am i f*cked and have to get new one? Some pics are attached

I had my motorcycle out last night it ran fine. Went for a little 5 min skoot down the road everything was good. On my way back, i started back firing and it wouldn't rev solidly over past say 3k. Im kind of lost to were to start looking. I had cleaned the carbs a little bit ago...