Search results

Bump TTT

BUMP TTT

Bump TTT

Bump TTT

I sell a Dual Disc Set-up for XS650 -- The rotors I use are from XJ750 Seca - They are thinner, weight alot less and bolt right on . . . Now about springs -- I installed a new set of Progressive Fork Springs from Mike's XS and they worked out great ! ! !

This will give you some idea ! ! ! http://www.xs650.com/forum/showthread.php?t=1282

Hold on Scrambled ! ! ! -- 2 disc sizes -- 10.5 inch diameter and 11.73 inch diameter -- The mounting points are different on the front fork legs . . . What do you have ? ? ? IF it is an XS650 - it should have 11.73 inch diameter.

If the bleeder is on the top -- it is a front caliper -- If it's on the side -- It's a rear caliper

BUMP TTT

Bump TTT

Plenty of them on Ebay ! ! !

Hi cdawg ! ! ! I had an ad in the Shops Section ! ! ! --- Have a look ! ! !

I only sell in the dual disc kits --- mainly because I really scrounge to find the rotors at a low enough price that I can put a kit together at a very reasonable rate . . . I never have disc just sitting around . . .

I sell Dual Disc Brake Kits for the XS650 and found the best setup is the Slotted Rotors from the XJ750 Seca . . . Same diameter, offset, 5MM thick and made of better metal composite . . . gangstahats@msn.com

Bump TTT

I sell a Dual Disc Add-on Kit . . So, I've got some knowledge in this area . . . The rotor shown are 10.5 inches in diameter whereas your XS650 is 11.73 inches diameter . . Would require changing front forks ! ! ! The caliper mounting is different than the XS650, which would require...

I sell Dual Disc Brake systems for XS650 . . These are usually an add-on setup but I think I can come up with everything for a complete Dual Disc system for you . . . Email me direct -- gangstahats@msn.com -- . . . I can send you a pic of my bike so you can see one installed --- This works with...

I can sell you a Dual Disc Kit that is lighter than the standard XS dual disc ! ! ! The slotted rotors are from a XJ750 and only 5MM thick (XS is 7MM thick) -- the caliper brackets on the backside is somewhat hollowed-out and not a solid block ! ! ! Email me @ gangstahats@msn.com ---...

I'm not sure of the configuration of the front brake system on the TX650 . . . I believe it has the calipers that bolt to the front of the forks . . . All my kits are for the later XS650 that bolt behind the fork . . . --- THANKS ---

The Rotor does not appear parallel with the fork leg and the caliper bracket is not parallel with the fork leg in the opposite direction . . . Are you sure your speedo drive notch at the top is fitting into the slot of the fork leg ! ! ! It appears to be holding out there ! ! !