bolts

So my question to you guys... If I were to purchase the stainless steel engine hardware kit. Would it be possible to carefully replace and re-torque each of these bolts without undoing and disturbing the engine gaskets etc. My engine is in perfect running order and I simply want to replace the...

Looking for parts for my 1979 xs650sf. Clutch hub Piston 75mm with 22mm wrist pin 6 clutch springs and/or bolts Located in Bakersfield, CA Please let me know! Thank you!

I need to find a replacement for a single missing rotor bolt (small bolt, attached the rotor to the spider) and 3 bolts for the spider (large, attaches the spider to the hub)... What sizes are the two types of bolts (thread, pitch, length)? I will be buying a complete set of each size to...

Hi. Most of my engine nuts and bolts seem in pretty good condition but have dirty rusty heads and nuts. Would it be a mistake to clean them up on my bench grinder with a wire brush wheel / abrasive pad or would that be okay? I was just wondering about their protective coatings. Cheers

I've removed the old rusty exhaust header bolts from a 1980SG engine. I used BP Blaster and two nuts jammed together to wrench 'em out. The tapped holes look ok to me. Question: Should I use Locktite on the new bolts? Any words of wisdom pertaining to installing the new bolts? BTW, this is...