coil

Hey guys I'm a little confused about what happened to my coil a few days ago. The right side exhaust in my bike since I got it running has had some backfire, nothing serious, or nothing too worrisome, until a few days ago. I was just pulling into second leaving my house When I heard an extremely...

Well I have looked everywhere for information regarding accell 3 ohm coil and boyer ignitions. It's very limited. I believe only a handful of guys are running this particular coil with electronic ignition. Some back story ... I got the bike with boyer ignition already installed. After...

Bought a Pamco original unit in 2008 .. the 1st unit he came up with. At the time Mikes #17-6803 coil was recommended and this combo has served me well for 5 years. I am electrically challenged. Bike quit yesterday, it has always worked great. Here is what happened: Went for a ride as usual ...

Hey everyone, Engine is back together. I took the bike for a quick ride yesterday and it ran great with tons of power. There was a strong backfire from the left side exhaust on deceleration, but other than that it was fine. The bike was really hard to start but thats the only complaint...

FINALLY doing the pamco install. My previous coil had a ground wire on the mounting screw on the ass side of the bike. Do I still need that on the new coil? I don't see a call out for that to be grounded in the wiring diagrams. Thanks for the fast help!

What is the primary terminal on the coil? the ones with power? I must be retarded or something... So Ive been riding my bike for like 3 weeks and NO problems. running perfectly. then today on what was supposed to be a quick trip home, i stopped at a light, idled fine, then when i went...

I have an 83 xs650 that I rewired and bobbed. Im almost done, but keep frying coils. I have checked everything that I can and the primary windings still check good, but the secondary windings check at 30k ohms. This is the second coil that ive done this too and don't know where the problem...

the Pamco electronic igntion calls out for a dual output coil similar to the MikesXS part #17-6810 or 17-6822. I have the 17-6822 and the 17-6803. I have been using the 17-6822 but am reinstalling a new Pamco and the 17-6803 will mount to my bike alot better than the 17-6822. my question...

some of you might be familiar with my story. i was riding with my new accell super coil on :bike: then i had one strong backfire and now i have no spark. i know i need a new coil and all but i was wondering just one thing. what happened during that backfire that killed my coil? :confused...

I just ordered an XS performance single tower hi performance coil from Mike's XS. Then when I went to install it, I realized the bike has two coils... I've got a 79 XS650 Special and now I'm wondering if I need two of these things since its only got a single tower? Thanks for your help! -j

A few years ago when I was messing with this bike before and had it running ('80 SG project) I had purchased and mounted up one of the black MikesXS aftermarket coils for the stock elec ig. bikes.it looks just like this: part # 17-6803 on his website. Visually it looks just the same. BUT...

I bought a new Pamco ignition from Mikes xs that has the double output green coil. Which terminal is the pos? I don't see any markings on the coil its' self and nothing in the installation instructions I got. Tells what wires go to pos, but not which terminal is pos. Looked through the tech...