flywheel

  1. jasidok

    No. Spark. Still.

    1978 xs650se. Her names Rose. Pamco ignition with e advancer. Pma and Reg/rec. removed old wiring and re wired. Removed safety relay and the two light relays. New dyno dual tower ignition coil. With new plugs and wires. New battery. New headlight. I don’t get it man. Could it be the Pamco/...
    • jasidok
    • Thread
    • #dontbeasucker #researchbeforeyoubuy cam clone coil e advancer e ignition flywheel gotcha help ignition mikesxs pamco pamco & e-advance pamcopete pma points sleezeballs spark xscharge
    • Replies: 34
    • Forum: The Garage
  2. WPGxs650_brat

    HHB CDI install

    Ill start off with email sent and awaiting response from Hugh, Got my kit today and wet at it. First issue I don't have a woodruff key like thei nstructions state. I looked on here on the site and I read it wasn't required so I continued on. (With the engine in TDC), after lining up the...
  3. anthony44

    Wanted - stock stator in good condition

    Rebuilding an engine on a budget so im looking for a stock charging system in nice condition that someone has laying around. I had a bunch of them in a box but threw them out last year so im pissed. Mostly looking for stator piece and a good points plate. All the ones on ebay seem shitty and...
  4. muskallunge

    PMA Banshee Swap Help

    I installed a Banshee rotor and a Kawasaki Vulcan/Drifter stator to my '78 xs650 using Hugh's Hand Built stator backing plate, stator mount & hardware. I had a wire rubbed through by the rotor rotation because I didn't tucked it away enough. When I pulled the rotor to inspect and fix the wire...
    • muskallunge
    • Thread
    • 1978 banshee swap flywheel hhb permanent magneto alternator pma rookie rotor stator xs650
    • Replies: 10
    • Forum: The Garage
  5. muskallunge

    PMA Stator/Flywheel Wear: Need Advice

    HHB PMA on my '78 xs650. The flywheel was slightly touching the stator wires that I thought were tucked away from danger and caused a wire to get exposed. This caused my battery to not get full voltage making the bike very poorly. I pulled the flywheel and noticed some wear on the inside in a...
    • muskallunge
    • Thread
    • 1978 flywheel hugh's handbuilt hugh's pma pma rubbing stator stator rotor wear xs650
    • Replies: 10
    • Forum: The Garage
  6. JayR

    Is this a chip in my flywheel? Your opinion would be appreciated.

    Hey boys. I was changing my sump filter for the first time and snapped a picture of the engine sump compartment from below. Is that dark area on the flywheel a chip or gouge or something? It looks like it but I'm a newbie when it come to diagnosing / evaluating engine wear and tear...
  7. S

    Question about PMA

    Hi all, I am looking to possibly buying parts or a kit to do a PMA swap on my 1980 Special. The PMA kit on MikesXS looks identical to the XS-Charge kit, and if true, would include a 130-Watt stator. Is there a big difference between the 130-Watt compared to say, 200-Watt or even 220-Watt...
    • Splexin
    • Thread
    • flywheel mikesxs pma rotor
    • Replies: 16
    • Forum: The Garage
Back
Top