hugh's pma

  1. muskallunge

    PMA Stator/Flywheel Wear: Need Advice

    HHB PMA on my '78 xs650. The flywheel was slightly touching the stator wires that I thought were tucked away from danger and caused a wire to get exposed. This caused my battery to not get full voltage making the bike very poorly. I pulled the flywheel and noticed some wear on the inside in a...
    • muskallunge
    • Thread
    • 1978 flywheel hugh's handbuilt hugh's pma pma rubbing stator stator rotor wear xs650
    • Replies: 10
    • Forum: The Garage
  2. mickeysolis

    Need a simple wiring diagram for PMA/Pamco, *including battery* using the stock turn key switch

    I'm new to the forum but have been reading threads for the last couple years. Finally got the chance to do an xs build myself after a friend with a garage sold me an '81 Special motor with an accompanying hard tail frame. I was stoked. I dug right in but due to work, rookie mistakes, and other...
    • mickeysolis
    • Thread
    • battery coil wiring hugh's pma pamco ignition pamco ignition system coils pamco install pamco pete pma swap electrical spark coil wiring stock ignition switch wiring diagram
    • Replies: 0
    • Forum: The Garage
  3. A

    PMA not charging bike

    I recently installed Hugh's PMA kit on my 79' Special II and my bike is not charging. I've chopped and hardtailed the bike and am running a brand new 12 Volt 3.4AH 12v 3.4 Amp-hr battery, kick only. I am only running led signal/ brake lights and 2.5"mini speedo. I attached the wiring diagram...
Back
Top