-
Enjoy XS650.com? Consider making a donation to help support the site.
XS650.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
o-rings
-
The great o-ring, seal, gasket, nut, bolt, sizes used on the XS650 thread.
BS34 carbs Throttle shaft seal Suzuki part # 13651-51010 SEAL I replaced the butterfly shaft seals with these Suzuki seals they fit perfectly. Cost a dollar less than the Yamaha seal ..... https://www.partzilla.com/product/suzuki/13651-51010 5twins tip BS34 mix screws 1mm thick x 3mm I.D...- gggGary
- Thread
- carb carbs fork forks gasket o-ring o-rings rocker cover seals valve cover
- Replies: 69
- Forum: The Garage
-
heiden big bore cylinder o-rings not allowing jug to seat fully
Hey guys, so ran into a problem tonight installing my new big bore cylinder into my engine. Previous to installing the pistons I dry fit my heiden tuning big bore cylinders onto my bottom end to confirm it fit nice and flat with no binding anywhere, all was good. Installed the base gasket, the...- Jaymichael
- Thread
- big bore engine o-rings
- Replies: 7
- Forum: The Garage
-
Replacement of O-Rings for New Valve Guides
Just received 4 new valve guides from Mikesxs. My old intake and exhaust valve guides had red o-rings on them (see images). Not sure whether I have the o-ring on properly in image 1 and image 2. YES, I DO. If o-rings are needed, what is a part number for these, either OEM or Mikesxs...- YL82
- Thread
- engine o-rings valve guides
- Replies: 0
- Forum: The Garage