pamco & e-advance

To the points… get it? I am running (trying to) an 82 motor with Hughs PMA, standard coil, and reg/rec setup, LED lights all buttoned up on a capacitor. For ignition I have the Pamco E-Advance. I’ve been struggling to get a healthy spark and constant power. After prodding and probing around...

1981 XS650 SH with a Pamco ignition with Eadvance. 2009 tag on the board so I'm pretty sure it's a legit Pamco. I'm trying to diagnose a no spark situation I got myself into. I was troubleshooting a charging system issue, jumped the Reg/Rec, and let it run a few seconds too long. I saw ~16.5V...

Ordered a Pamco with the E-Adv on the plate and paid with PayPal and I got a refund. Any indication as to why? I Pete out of business or out of units? Thanks

1978 xs650se. Her names Rose. Pamco ignition with e advancer. Pma and Reg/rec. removed old wiring and re wired. Removed safety relay and the two light relays. New dyno dual tower ignition coil. With new plugs and wires. New battery. New headlight. I don’t get it man. Could it be the Pamco/...

Sadly up for sale due to work, baby, life blah. Custom chop. Slab yokes, newly rechromed forks, twin spoke wheels, recently rebuilt engine - new pistons and rings, rebored to 1st OS. PMA. boyer brandson e-ignition. 8 plate clutch. Inverted sides mustang tank. VM 34's Needs a bit of work...

Need help!, I installed both e advancer and pamco ignition. Here is the issue? No spark. 1. checked battery with load meter and is good. 2. Meter on battery reads 13.45 3. Unit is switched and fused. Both continuity meter fine 4. Voltage between red and green connection between sensor...

My stock 1980 tci coil and ignition box finally gave out so it's time for a pamco. I'm currently installing the Ultimate Pamco electronic ignition kit with e-advancer/ignition coil kit Part # 14-0907 from Mikes. I know this has been covered 100 times before but I'm having trouble finding a place...

I've been working on rebuilding an XS and I've come up with no spark. I started going through the PAMCO system as per Pete's instructions on here and when I got to testing the green wire's voltage when spinning the rotor, I found that the voltage was remarkably low (3v, compared to the...

Hey everyone. I'm new here and new to XS650's as well, so please forgive my dumb questions. I've built Ford small block racing engines as well as Porsche engines, so I'm not a complete idiot, but I've never been able to tear into a complete, running XS650 motor. My bike was a basket case...