pamcopete

  1. Robert Dell Aquila

    Carb fuel flow

    Hi yall, trying to figure out my idle issue with my 78'XS650-E 277 rephased. Running pamco 277 ignition with 3 ohm single output coils. Intitially my bike would idle fine then die after about 10 minutes and not start back up. Now it does not idle at all after I cleaned the carbs. Since I'm...
  2. jasidok

    No. Spark. Still.

    1978 xs650se. Her names Rose. Pamco ignition with e advancer. Pma and Reg/rec. removed old wiring and re wired. Removed safety relay and the two light relays. New dyno dual tower ignition coil. With new plugs and wires. New battery. New headlight. I don’t get it man. Could it be the Pamco/...
    • jasidok
    • Thread
    • #dontbeasucker #researchbeforeyoubuy cam clone coil e advancer e ignition flywheel gotcha help ignition mikesxs pamco pamco & e-advance pamcopete pma points sleezeballs spark xscharge
    • Replies: 34
    • Forum: The Garage
  3. cbuckle

    PAMCO timing jumping around

    Hello, I just upgrade my Ignition from points to PAMCO Ultimate High output #14-0914 (thanks http://www.xs650direct.com/ ), using the stock advace. Ive grounded the PACMO to the old coil bracket on bare metal, disconnected the condensors(left them floating), connected the remaining orange wires...
  4. J

    PAmco Pete Help Please

    Hi Guys, new to the Forum I was reading in here about the issues with the Pamco system with the PMA on friday afternoon when my customers 78 XS650 Died I installed the Pamco and the PMA last summer, he took the bike and finished some more fab on it - Bike was running ok but needed tuning. We...
Back
Top