pilot jet

  1. H

    Proper Jetting and Fuel/Air Screw Position Mikuni VM-34 on a 1972 Yamaha XS2 (650)

    I’ve posted a few times about this bike. Bought it a few weeks ago. Did quite a bit of road worthy maintenance / repairs on it before I could take if for its first test ride. Idles good, low throttle stutters and extremely sluggish, 3k and above seems to run good. Pulled right carb tonight to...
  2. R

    Should I Be Worried? (Pilot Jet)

    So I’ve been having some carb trouble - I think I’ve finally got it sorted out, ridiculously high idle, replaced the diaphragms/slides - and I took my carbs apart yesterday... You know that rubber piece that goes in under the pilot jet? Well after I drained my carb, it was all swollen. Why is...
  3. L

    Spitting/coughing through carb ...

    Hi, I have a problem with my bike Spitting/coughing through carb ... Here is my status: -Pma/pamco setup -timing done -cam chain adjustment done -carb sync done -carbs are cleaned folowing guide. -battery fully charged -floats verified and needle cleaned -throttle seals changed...
  4. Kgreenhaw

    BS38 Float Bowl Issues

    I recently rebuilt my engine and was having issues with one of the cylinders running rich at idle. I went through everything and finally found what the problem was. The float bowl. I swapped carbs from left to right and the rich condition followed the carb. I then swapped float bowls and the...
  5. S

    no hole pilot jet or jet with holes ?

    hi, i have a 79 (sf) 650 special with 38 carbs. the pilot jets have no bleed holes and have 275 stamped on them. i was just wondering if these were the right pilot jets as i have seen similar ones with bleed holes why do some jets have no holes and others bleed holes and does it make any...
Back
Top