Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Enjoy XS650.com?Consider making a donation to help support the site. XS650.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
I have been looking every where for a Complete oil seal kit for my 73' tx650 and I am in need of some help.
I found this on ebay https://www.ebay.com/i/363178151307?ul_noapp=true let me know what you guys think, or would recommend.
Hello,
I have a set of forks I'm trying to rebuild and I've got a bit of a quandary. I purchased this set of forks with my XS650 under the assumption that they were XS650 forks but that does not appear to be the case! 5twins suggested in another thread that they may be from an XS500 given that...
Hello folks,
I've got me heart set on a nice set of TCBros front springer forks. the construction looks super solid from their video, and they come with lots of support in terms of calipers, bar mounts, and all that rigamarole. the trouble is, with all this corona quarantine happening i am...
I have a low mile '78 that runs pretty good.
The gaskets are original and a little leaky. I want to go through and replace with a kit.
What would be the best resource for me to look at for this?
Thanks
BS34 carbs
Throttle shaft seal Suzuki part # 13651-51010 SEAL
I replaced the butterfly shaft seals with these Suzuki seals they fit perfectly. Cost a dollar less than the Yamaha seal .....
https://www.partzilla.com/product/suzuki/13651-51010 5twins tip
BS34 mix screws 1mm thick x 3mm I.D...
Looking for throttle shafts for XS650 BS34 carbs. I need the plate and shaft for the right carb for sure but will likely need both. My carbs are 1980 and I am assuming that all bs34's for xs650s were the same except for the floats.
Working on my 1980 XS and found I had leaking carb shaft seals. Ground down the staked ends of the throttle plate screws but could not get the screws out. I tried drilling out the screws on the right carb and fear I didn't get the drill centered in the screw and will never get the threads clean...
Hi There,
I started working on replacing my countershaft seal and I got stumped on the first step!
I was using the instructions that were posted online and it just says to remove the seal with a small flat screwdriver. Well I tried that and it was stuck in there really good. It wouldn't come...