throttle shaft

  1. R

    Replace Throttle Shaft Seals. Can See Light in Butterfly Valves

    I replaced my throttle shaft seals (following the ideas found in the comments found in this long thread). I used a small dremmel HHS cutter to remove the back of the threads on the two screws and then used a Philips head screwdriver. These screws came out flawlessly. I'm concerned that when I...
    • rjz1
    • Thread
    • butterfly valve butterfly valve close carburetor close gap light seal throttle shaft throttle shaft seal
    • Replies: 17
    • Forum: The Garage
  2. eight0

    Cleaning and rebuilding my XS2 carbs

    Hi All, So I've been reading this site, the carb guide and watching as many videos as I can about carbs and the time has come to take my XS2's BS38's apart. I should point out that I have never taken apart a carb before... When I bought the bike it ran but when the petcocks were turned on it...
    • eight0
    • Thread
    • bs38 carb carbereters floats throttle shaft ultrasonic xs2
    • Replies: 22
    • Forum: The Garage
  3. F

    BS34 Rebuild - Throttle Shaft lateral movement

    Hi Lads, Nearly finished my way through rebuilding 2 sets of BS34 carbs, everythings been hydro blasted, plated, cleaned and sealed. One thing I forgot to do and was hoping for some help with was measure how much play the throttle shaft shown in the picture attached has. I've re-installed...
    • FreoWA
    • Thread
    • bs34 carburetors spacing throttle shaft
    • Replies: 1
    • Forum: The Garage
Back
Top