Just Plain Bill
XS650 Addict
Found a seat pan - no longer need one.
Looking for a factory steel seat pan in good condition - with minimal rust from a 1974 through 1977 Standard TX or XS 650. I don't need foam, a cover, hinges, or a latch. And because I got thoroughly screwed buying a rusted out POS seat from Oregon, I'd like to hold the cost to a minimum.
Also, because you never know what kind of seat somebody might have put on any XS650, here's a picture of exactly the seat pan I need. Notice there's almost an "X" embossed in the front of the pan and two more embossed strengthening "bars" after that. Another distinctive feature is six 3 mm diameter round holes in the sides of the pan for clips holding the trim piece that goes around the finished seat cover on three sides.
If you have one to sell, send a PM -- and I'd like to see a photo too. I will revise this post when I have one.
Bill
Looking for a factory steel seat pan in good condition - with minimal rust from a 1974 through 1977 Standard TX or XS 650. I don't need foam, a cover, hinges, or a latch. And because I got thoroughly screwed buying a rusted out POS seat from Oregon, I'd like to hold the cost to a minimum.
Also, because you never know what kind of seat somebody might have put on any XS650, here's a picture of exactly the seat pan I need. Notice there's almost an "X" embossed in the front of the pan and two more embossed strengthening "bars" after that. Another distinctive feature is six 3 mm diameter round holes in the sides of the pan for clips holding the trim piece that goes around the finished seat cover on three sides.
If you have one to sell, send a PM -- and I'd like to see a photo too. I will revise this post when I have one.
Bill
Attachments
Last edited: