1. Dismiss Notice
  2. Hey Facebook people... We've created a group for XS650.com members to connect. Check it out!
    Dismiss Notice

Carb brace hole spacing

Discussion in 'The Garage' started by J_Dubb, Mar 25, 2020.

Tags:
  1. J_Dubb

    J_Dubb XS650 New Member

    2
    1
    3
    Ohio
    Hello all,

    While tearing down my bs34’s for a rebuild, I stripped the very soft screws on the brace on the bottom. To be able to work on the separately, I took a sawzall to it thinking I could just find another one.... I can’t. Can’t even find the correct dimensions for hole placement to just fab up a new one. Any one have this info?? Thanks
     
  2. Jim

    Jim Beyond the edge, is the unknown. Here be Dragons XS650.com Supporter Top Contributor

    As you found out, parts for these old bikes are getting pretty precious. Do us all a favor... try and save 'em from now on.

    Untitled.png
     
    GLJ and Team Junk like this.
  3. J_Dubb

    J_Dubb XS650 New Member

    2
    1
    3
    Ohio
    I was young and dumb. Can’t thank you enough!
     
    Jim likes this.
  4. Jim

    Jim Beyond the edge, is the unknown. Here be Dragons XS650.com Supporter Top Contributor

    I suspect you could round that 89.86 up to an even 90mm. Possible there's a burr or two on the one I measured.
     
    J_Dubb and Greyandridin like this.

Share This Page