For Sale - Custom wiring harness

[member3480]

OK again I got a lot of interest on wire harnesses so I am again going to lay out the KITS and Prices

1. Plan Harness $125.00 shipped in USA

3 Wire Headlight with Switch HIGH/OFF/LOW
3 Wire Tail Light with New Switch BRAKE/RUNNING/GROUND
2 Wire Horn with Button Switch
4 Position Fuse Box New
Ignition Switch for KICK or ELECTRIC START
TC Brothers or PAMCO/BOYER/PMA wires
All wires shrink wrapped and marked for easy install

2. CUSTOM $160.00

All of the above but add turn signals and handle bar switch

3 Full Custom $275.00

Fake Oil Tank (switches mounted to it) and battery box
and all of number1 Number 2 would be extra added if wanted.

I can make just about any type of harness you want. All the wires are 16 guage.
I am doing three this week and may have 2 to do next week . Turn around time is 2 weeks and if you want to try it yourself I am here to walk you threw it JUST email me at DADDYGCYCLES@YAHOO.COM
Thanks hope I answered all the questions
I make harnesses for KZ-GS-Harley-CB-Triumph-BSA-Norton and of course XS650
Have a great weekend.

 

[DannyB]

Can you do the number one with the Capacitor wiring to run with the PAMCO and PMA to run battery less?

 

[80brat]

I bet he can good guy to deal with KEN

 

[member3480]

you want this one

 

[DannyB]

Yes sir that is it. Include the capacitor with it would be awesome.

 

[member3480]

Yep just like that with the Sparx and switches $125.00 for harness

 

[jtrip72]

Yep just like that with the Sparx and switches $125.00 for harness

How much for the above minus the capacitor ( I have one already)?

 

[member3480]

My basic harness with wires for lights front back- brake switch- ignition switch-fuse block-horn-neutral light-all wires shrink wrapped and marked for stock or aftermarket IGNITION and CHARGING systems is $125.00
If you want a custom harness to your specs its extra
I have done them many ways with aftermarket switches or stock handlebar switches
. Just depends what you want.
All of my harnesses are market for easy install.

 

[jtrip72]

PM sent.

 

[member3480]

Here are the questions I am going to ask.
HEADLIGHT 2 wire 3 wire?
TAIL LIGHT 2 wire 3 wire?
PAMCO/PMA/or STOCK and where you putting stock REG/REC/TCI
POSITION of Tail Light Fender or Side Mount
HORN?
COIL stock mount?
DRUM or DISK rear wheel (brake switch different)
Kick or Electric Start (Ignition Switch Different)
POSITION of Switches Under Seat or Light Bucket
Do you want switches in a incloser (small Box)
NEUTRAL LIGHT?